TM 10-4320-344-242.14.1.4 Service.Compressed air used for cleaning purposes must not exceed 30 psi (207 kPa).Use only with effective chip guarding and personal protective equipment.Failure to obey this warning may result in personal injury.a .Using compressed air hose clean filter element (25).Blow dust from inside offilter element (25) outward.Clean outside of filter element (25) withcompressed air.b .Cover large end and look through small end of filter element (25).I f l i g htcannot be seen through paper element or hole is present, replace filterelement (25).2.14.1.5 Repair.Do not use cleaning solvent without proper ventilation and clothing.Do notsmoke or use near open flame or excessive heat.Dry cleaning solvent ispotentially dangerous to personnel and property.Clean parts in a well-ventilated area.Avoid inhalation of solvent fumes.Wear goggles and rubbergloves to protect eyes and skin.Wash exposed skin thoroughly.Failure toobey this warning may result in personal injury or death.a .Using cleaning rag dampened with cleaning solvent, wipe inside of air cleaner(3), end cap assembly (21), vacuum diaphragm (22), and air cleanerb a f f l e ( 2 3 ).b.Replace all defective components.2.14.1.6 Assembly.a.b.c .d .e .Install pressure indicator (27) and air cleaner cap (26) on air cleaner (3).Install filter element (25) in air cleaner (3) and secure with wing nut (24).Install air cleaner baffle (23) in vacuum diaphragm (22) on air cleaner cupassembly (21).Position retaining clamp (20) and air cleaner cup assembly (21) on air cleaner( 3 ).Center retaining clamp (20) over air cleaner cup assembly (21) and air cleaner( 3 ).Tighten screw (19) to secure air cleaner cup assembly (21).2.14.1.7 Installation.a .Position mending plate (18) and mounting bracket (14) and secure with twob o l t s ( 1 7 ), new lock washers (16), and nuts (15).b .Position air cleaner mounting plate (10) on mounting bracket (14) and securewith two bolts (13), new lock washers (12), and nuts (11) .When installing mounting brackets on mounting plate, make sure that the openend of each mounting bracket is on same side of mounting plate facing towardsthe radiator.2-93
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business