(1)(2)(3)TM 10-4320-344-10Check ENGINE COOLANT TEMPERATURE gauge (8) and ENGINE LUBE OIL PRESSUREgauge (9) .If engine temperature or oil pressure is not within properl i m i t s,shut down engine (step k below).Reset engine alarm by pushing ENGINE ALARM reset button (2).Notify unit maintenance.CAUTIONTo prevent damage to engine, DO NOT shutfull-load running.k.To stop engine, turn MANUAL THROTTLELet engine idle for 2 or 3 minutes.p o s i t i o n .Engine will shut down.down engine suddenly from(6) clockwise to fully in position.Push engine switch (5) left to OFFl .Turn FUEL RACK handle (7) counterclockwise and release.m.Perform "After" PMCS (Table 2-10).2.5.1.2 Electric Manual Mode.Before starting pumping assembly 609-A, make sure thatthe pump has been primed (paragraph 2.4.1 or 2.4.2) .Refer to Figure 2-20 andstart and operate Model 609-A as follows:a.Perform "Before" PMCS (Table 2-10).b.Turn PRESSURE REGULATOR SWITCH (8) counterclockwise to START position.c .Turn ELECTRIC SPEED CONTROL (6) counterclockwise to IDLE position.d.pull out MODE SWITCH (4) and set to PRESSURE REGULATOR (NORMAL) Position.e .Turn MANUAL THROTTLE (7) clockwise until it is fully in.f .Turn FUEL RACK handle (9) left to UNLOCK position.Push handle fully inand turn right to LOCK position.To avoid hearing loss, hearing protection must be worn by personnelstanding within 50 feet of operating pumping assembly.CAUTIONTo prevent damage to starter, allow 3 minutes between start attempts.Engine alarm will sound if engine does not start within 30 seconds afterENGINE SWITCH is set to START position.g .Push ENGINE SWITCH (5) right to START position and hold for no more than 30seconds or until engine starts.When engine starts, release ENGINE SWITCH( 5 ) .Engine will run at idle speed (1,000 rpm).If engine alarm sounds:2-91WARNINGNOTE
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
