TM 10-4320-325-14
TO 34Y5-2-40-1
This task covers:
a) Removal
b) Inspection
c) Installation
INITIAL SETUP
Tools
Equipment Condition
Tool Kit, General Mechanics
(Item 1, Appendix B, Section III)
removed
REMOVAL:
a. Remove four nuts (1) and washers (2) from bolts (3) attaching engine base plate (4).
b. Remove engine base plate (4) from frame (5).
c.
Remove four hex head bolts (6), nuts (7), and flatwashers (8) from engine base plate (4).
Note
Never replace only one shock mount. If one shock mount requires
replacement, then replace all four shock mounts at once.
INSPECTION:
Inspect and replace damaged shock mounts (9).
INSTALLATION:
a. Install four hex head bolts (6) through engine base plate (4), and install four spacer nuts (7) and
washers (8) on top of engine base plate (4).
b. Install four hex head bolts (3) and washers (2) from bottom into frame (5).
c.
Install shock mount (9) into bottom of engine base plate (4).
d. Install base plate (4), and four washers (2) and nuts (1).
Change 4
