TM 10-4320-325-14
(2) Remove fuel Injection pump.
(3) Add or remove shims (7) to achieve a timing of 14 degrees, plus or minus 1 degree before top dead center.
(4) Install fuel Injection pump and repeat test.
b. Fuel Injection Volume Limitation Adjustment.
(1) Refer to Figure 5-5 Loosen hex nut (2) and remove pump viewing access plate (3) and gasket (4).
(2) Refer to Figure 5-6 Adjust speed control lever knob until the control lever pointer (2) lines up with access
hole match marks (1).
(3) Refer to Figure 5-8 Adjust the fuel limiter adjust screw (1) until the tip lightly touches the governor lever (2).
(4) Refer to Figure 5-5 Install pump viewing access plate (3) and gasket (4), and tighten hex nut (2).
5-20
