2-61. MAINTENANCE OF WIRING HARNESS AND TAIL LIGHTS.

Figure 2-49. Wiring Harness and Tail Lights

TM-10-4320-315-24 Pumping Assembly Water 600 GPM Trailer Mounted (NSN 4320-01-31448844) Manual
Page Navigation
124

TM 10-4320-315-24 2-61. MAINTENANCE OF WIRING HARNESS AND TAIL LIGHTS. This task covers: a. Remove b. Install INITIAL SETUP: Tools Equipment Conditions General Mechanics Tool Kit Pumping assembly is shutdown (refer to TM 10-4320- (Item 1, Appendix B) 315-10). Materials/Parts Lockwashers (TM 10-4320-315-24P) a. REMOVE. (Figure 2-49) (1) Remove tail lights as follows: (a) Open engine access doors. (b) Disconnect wire connectors (1) to tail light (5). (c) Remove nuts (2), lockwashers (3), ground wire (4), and plate (5) holding tail light (6) to panel (7). Remove tail light. (d) Remove screws (8) and lens plate (9) on tail light assembly (6). (e) If necessary, remove bulbs (10). (f) Perform steps (b) through (e) and remove the second tail light. (2) Remove wiring harness as follows: (a) Remove nut (11) that secures elbow (12) to floor of chassis. Remove elbow (12) and tail light wires (13) to below chassis. (b) Loosen compression nut (14) from elbow (12). Remove elbow (12) from tail light wires (13). (c) Remove nut (15), lockwasher (16), flat washer (17), and bolt (18) that secure clamp (19) on cable harness (20). (d) Pull wiring harness (20) out from cable route on curbside of trailer chassis (21). b. INSTALL. (1) Install wiring harness as follows: (a) Route wiring harness (20) onto trailer chassis (21) starting at front of trailer. (b) Pull end of wiring harness (20) aft through openings in cable route of trailer chassis (21). 2-122

Privacy Statement
Press Release
Contact