TM 10-4320-315-24
2-60. MAINTENANCE OF HAND BRAKE ASSEMBLY
This task covers:
a.
Remove
c.
Adjust
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Wheel, Tire, and Hub assembly removed (para. 2-58).
(Item 1, Appendix B)
Ends of rear brake cable disconnected from each
Materials/Parts
brake shoe assembly (para. 2-59).
Lockwashers (TM 10-4320-315-24P)
a.
REMOVE. (Figure 2-48)
(1)
Release handbrake lever (19).
(2)
Remove nuts (1 and 2), flat washers (3), and spring (4) holding rear cable (6) to front cable (5).
(3)
Remove nuts (7), lockwashers (8), and bolts (9) holding two cable hanger clamps (10) to trailer chassis
(11).
(4)
Remove nut (12), lockwasher (13), and bolt (14) holding two clamps (15) to trailer.
(5)
Remove front cable (5) from handbrake lever (19).
(6)
Remove nuts (16), lockwashers (17), and bolts (18) holding handbrake lever (19) to trailer chassis (11).
(7)
Remove cotter pin (20) and pin (21) holding front cable (5) to handbrake lever (19).
b.
INSTALL.
(1)
Connect front cable (5) to handbrake lever (19) with pin (21) and cotter pin (20).
(2)
Install handbrake lever (19) to trailer chassis (11) with bolts (18), lockwashers (17), and nuts (16).
(3)
Install front cable (5) on handbrake lever (19).
(4)
Install rear cable (6) on trailer chassis (11) with cable hanger clamps (10), bolts (9), lockwashers (8), and
nuts (7). Install two clamps (15) on rear cable (6) with bolt (14), lockwasher (13), and nut (12).
(5)
Attach rear cable (6) to front cable (5) with spring (4), flat washers (3), and two nuts (1 and 2).
2-119
