TM 10-4320-315-24
2-58. MAINTENANCE OF WHEEL, TIRE, AND HUB ASSEMBLY-(Cont)
CAUTION
Do not force hub and tire assembly on spindle. Forcing could cause bearing damage.
(3)
Install hub assembly (9) on spindle (14).
(4)
Install outer bearing (8), washer (7), locking washer (6), and spindle nut (5).
(5)
Tighten spindle nut (5) until there is a slight bind, then back off to nearest locking hole in spindle nut.
(6)
Bend tab of locking washer to lock position.
(7)
Install dust cap (4).
(8)
Place wheel and tire assembly (3) on hub (9) with valve out located halfway between two studs of hub.
(9)
Install wheel clamps (2) and nuts (1). Hand tighten.
(10)
Tighten in an every-other-one sequence to 20 ftlbs (21.1 Nm). Continue tightening around wheel in the
same order. Increase torque by 10 ftlbs (13.6 Nm) each time until each bolt is torqued to 90 ftlbs (122
Nm).
(11)
Lower trailer to ground.
2-115
