TM 10-4320-315-24
2-61. MAINTENANCE OF WIRING HARNESS AND TAIL LIGHTS-(Cont)
(c)
Install clamp (19) on wiring harness (20) with bolt (18), flat washer (17), lockwashers (16) and nut
(15).
(d)
Route wiring harness (20) over axle (22).
(e)
Feed tail light wires (13) through elbow (12). Secure with compression nut (14).
(f)
Position tail light wires (13) and threaded end of elbow (12) up through trailer chassis (21). Secure
with nut (11).
(2)
Install tail lights as follows:
(a)
If removed, install bulbs (10).
(b)
Install lens plate (9) on tail light (6) with screws (8).
(c)
Install tail light (6) on rear panel (7) with plate (5), ground wire (4), lockwashers (3), and nuts (2).
(d)
Connect wire connectors (1) to each tail light (6).
2-124
