TM 10-4320-315-24
2-62. MAINTENANCE OF LEVELING JACKS AND TRIPOD JACK ASSEMBLY
This task covers:
a.
Remove
b.
Install
INITIAL SETUP:
Tools
Equipment Conditions
General Mechanics Tool Kit
Pumping assembly is shutdown (refer to TM 10-4320-
(Item 1, Appendix B)
315-10).
Materials/Parts
Lockwashers (TM 10-4320-315-24P)
a.
REMOVE. (Figure 2-50)
(1)
Remove leveling jacks as follows:
(a)
Remove all weight from leveling jack to be removed.
(b)
Drive out pin (1).
(c)
Remove leveling jack (2) from trailer bracket (7).
(d)
Remove nut (3), lockwasher (4), bolt (5) and pad (6) from leveling jack (2). Note position of pad.
(2)
Remove tripod jack assembly as follows:
(a)
Remove all weight from tripod jack assembly (8).
(b)
Remove locknuts (9) and bolts (10) holding A-frame (11) to brackets (12).
(c)
Remove snapring (13) holding tripod jack (14) to front jack bracket (15).
(d)
Remove tripod jack assembly (7).
(e)
Remove nut (16), lockwasher (17), bolt (18), and tripod jack (14) from A-frame (11).
(f)
Remove nut (19), lockwasher (20), bolt (21), and pad (22) from A-frame (11).
(g)
Remove bolts (23), nuts (24), lockwashers (25), and brackets (12) from chassis (26).
b.
INSTALL.
(1)
Install tripod jack assembly as follows:
(a)
Install bracket (12) on chassis (26) with bolts (23), lockwashers (25) and nuts (12).
(b)
Attach pad (22) to A-frame (11) with bolt (21), lockwasher (20), and nut (19).
(c)
Attach tripod jack (14) to A-frame (11) with bolt (18), lockwasher (17), and nut (16).
2-125