TM 10-4320-310-14
2-4.
OPERATING PROCEDURE (Continued)
d.
Stopping.
CAUTION
Immediate shutdown of the engine without a 5minute idle time
may cause damage to engine. Do so only when made
necessary by overriding system requirements or emergency
conditions.
(1) Slowly move throttle control hand lever (1) to right position to idle speed stop (2). Allow engine to
idle for 5 minutes to allow engine operating temperature to stabilize.
NOTE
If centrifugal pump unit is to be reused In its present placement
and alignment, be prepared to close suction and discharge
valves on hoses attached to the pump. This will retain fluid In
pump housing and reduce or eliminate priming requirements.
(2) Move throttle control hand lever (1) to extreme right position.
(3) Close any suction and discharge couplers or adapters that are installed on hoses after operation is
complete.
2-27
