2-4. OPERATING PROCEDURE

Section III. OPERATION UNDER USUAL CONDITIONS - TM-10-4320-310-14_37

TM-10-4320-310-14 Pump Unit Flammable Liquid Centrifugal Self-Priming 2-Inch 100 GPM Diesel Engine Driven NSN 4320-01-263-3604 Manual
Page Navigation
31

TM 10-4320-310-14 2-3. ASSEMBLY AND PREPARATION FOR USE (Continued) (8) Connect clamp and ground cable to ground rod and securely tighten screw. c. Perform category B (before operation) PMCS contained in Table 2-2 or verify that category B PMCS was performed. Report any problems to unit maintenance. d. The following paragraphs contain instructions for starting, operating and stopping the unit. 2-4. OPERATING PROCEDURE CARBON MONOXIDE (EXHAUST GAS) CAN KILL YOU Exposure to exhaust gases produces symptoms of headache, dizziness, loss of muscular control, drowsiness, or coma. Brain damage or death can result from severe exposure. Fumes from engine become concentrated with poor ventilation. Operate engine in a ventilated area only. While running engine, be alert for fumes. Keep area ventilated. If someone Is overcome, expose to fresh air; keep warm and still; give artificial respiration If needed. Seek medical attention. Administer oxygen, if available. GOOD VENTILATION IS THE BEST DEFENSE AGAINST EXHAUST POISONING. a. Preparation for starting. (1) Move throttle control hand lever (1) fully to left past stop (2). (2) Pull out extra fuel device button (3) until fully extended. (3) Turn decompression lever (4) clockwise to 12 o'clock position (position 2).If decompression lever is in the 6 o'clock position, hand cranking will be extremely difficult. 2-24

Privacy Statement
Press Release
Contact