TM 10-4320-307-244-6SPEEDINCREASERREPAIR(CONT).n.Apply sealant M-2828 to inside diameter ofwear sleeve (25) and install new wearsleeve (25) onto shaft (11) using wearsleeve driver T-20134.o.Apply sealant M-2828 to inside diameter ofwear sleeve (26) and install new wearsleeve (26) onto the rear of gear shaft (23)using wear sleeve driver T-20135.p.Apply sealant M-2828 to outside diameter ofoil seal and install oil seal (27) with lip towardoil being retained. Seat seal against shoul-der in bore of bearing carrier (28). Seat oilseal using a flat disc that is 4-5/8 (117.47mm) diameter x 1/2 (12.7 mm) inch thick.q.Install taper roller bearing outer race (29)into bearing carrier (28) and seat it againstshoulder in bore of bearing carrier (28).r.Install gasket (30) and bearing carrier (28).Secure with screws (31). Torque screws to27 +2 ft-lbs (36.60 +2.71 N.m).s.Install shaft (11) using extreme care not tocut oil seal.t.Install shaft gear (23).4-29
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business