TM 10-4320-307-24
3-36
CYLINDER HEAD ASSEMBLY/INSPECT/REPLACE (CONT).
INSTALLATION:
NOTE
Make sure the side of the gasket marked TOP is
up.
1.
Install new gaskets (1) on dowel pins in cylinder
block (2).
2.
Install two guide studs in the block for each cylin
der head.
3.
Install cylinder heads over guide studs and dowel
pins.
4.
Remove guide studs.
5.
Use clean oil to lubricate cylinder head capscrews
and both sides of flat washers.
6.
Allow excess oil to drain from threads.
7.
Install 12 capscrews and washers ineach cylinder
head.
8.
Torque cylinder head capscrews (3) in sequence
shown as follows:
a.
25 ft-lbs (35 N.m)
b.
100 ft-lbs (135 N.m)
c.
285 ft-lbs (385 N.m)
d.
Repeat steps a, b, and c for each cylinder
head.
3-133
