TM 10-4320-307-24
3-36
CYLINDER HEAD ASSEMBLY / INSPECT/REPLACE (CONT ).
f. Use wire gauge to check clearance (1 and 2)
between crossheads (8) and valve spring
retainer (9). Clearance must be a minimum of
0.025 inch (0.65 mm).
NOTE
The injector push rods are larger in diameter than the valve pushrods.
15.
Install rocker lever housings-in accordance with paragraph 3-33.
16.
Adjust valves and injectors in accordance with paragraph 2-54.
17.
Install water manifold in accordance with paragraph 2-45.
18.
Install exhaust manifold in accordance with paragraph 2-46.
19.
Install turbochargers in accordance with paragraph 2-40.
20.
Install rocker housing covers in accordance with paragraph 2-53.
21.
Install aftercooler assembly in accordance with paragraph 2-47.
22.
Fill cooling system in accordance with paragraph 2-35.
3-135
