TM 10-4320-307-24
2-13
PRELIMINARY SERVICING AND ALIGNMENT. Prior to operation, the pumping assembly requires servicing of
the following components and systems: pump, speed increaser, battery, engine fuel system, lubrication system, engine
air connections, and engine coolant. Refer to 2-13.1 through 2-13.7 for procedures. Refer to Chapter 3 for alignment
and installation of the pump and speed increaser shafts.
2-13.1 INITIAL LUBRICATION OF PUMP.
NOTE
Use pump bearing oil MIL-L-46167 Grade
ARCTIC or MIL-L-2104 Grade 15W-40.
a.
Remove oil fill cap (1).
b.
Fill until oil sight glass (2) shows oil sump is full.
c.
Replace oil rill cap (1).
d.
Repeat steps a through c for opposite side
bearing lubrication.
2-13.2 INITIAL LUBRICATION OF SPEED INCREASER.
NOTE
Use speed increaser oil MIL-L-46167 Grade
ARCTIC or MIL-L-2104 Grade 15W-40
a.
Remove oil fill plug (1).
b.
Fill oil sump to proper level full mark on dipstick (2).
c.
Replace oil fill plug and tighten.
2-12
