TM 10-4320-307-24
2-38
AIR CLEANER ASSEMBLY SERVICE/REPAIR/REPLACE (CONT).
2.
Install primary and secondary elements as follows:
a.
Install secondary element (4) into body assembly.
Align hole in element with threaded rod.
CAUTION
Hand tighten nut assembly as necessary to make a tight,
vibration-free installation. Overtightening the nut will
deform the element.
b.
Install nut (3), hand tighten, and install cotter pin.
c.
Install primary element (2) over secondary element
(4). Align hole in element with threaded rod.
CAUTION
Hand tighten nut assembly as necessary to make a tight,
vibration-free installation. Overtightening the nut will
deform the element.
d.
Install wing nut (1) and hand tighten.
e.
Reset air cleaner intake restriction indicator if
necessary.
REMOVAL:
1.
Remove primary and secondary elements in accordance with step 1 of Service task.
2.
Loosen clamp (1) on air cleaner cap (2) and remove from air cleaner (3).
3.
Loosen clamps (4 and 5) and remove hose elbow (6).
4.
Loosen clamp (7) and remove air inlet tube (8).
5.
Loosen clamp (9) and remove hose elbow (10).
6.
Loosen clamp (11), slide off tube brace (12), and remove air tube (13).
7.
Remove two screws (14) and lockwashers (15), and remove tube brace (12) from engine.
8.
Loosen clamp (16) and remove hose elbow (17).
9.
Unscrew restriction indicator (18) from air inlet tube (19).
10. Loosen clamp (20) and remove air inlet tube (19).
11. Loosen clamp (21) and remove hose elbow (22).
12. Remove screw (23), lockwasher (24), and nut (25) from each of the two air cleaner straps (26).
13. Remove air cleaner (3).
14. Remove two screws (27 and 28), two lockwashers (29), and two plain washers (30).
15. Remove air cleaner bracket (31) and two clamp halves (26).
2-140
