TM 10-4320-226-14
4.10.3.1 Removal.
To prevent rolling or sliding,
do not work on equipment that is
not securely stabilized.
Ensure both wheels are secure.
Failure to obey this warning may result in serious personal
injury.
a.
Tag and disconnect two hoses (figure 4-6, 1) from reservoir (2).
b.
Remove two nuts (3) and external tooth lockwashers (4) .
c.
Remove reservoir (2).
4.10.3.2 Repair.
a.
Disconnect other end of hose from ether cold start pump or cold start nozzle.
b.
Manufacture new hose in accordance with appendix F.
c.
Connect new hose to cold start pump or cold start nozzle.
4.10.3.3 Installation.
a.
Position reservoir (2) in bracket with lid pointed upward.
b.
Install two external tooth lockwashers (4) and thread nuts (3) on
reservoir (2) .
c.
Tighten two nuts (3).
Connect pump hose to inner connection of reservoir.
d.
Connect two hoses (1) to reservoir (2).
4-20
