TM 10-4320-226-14
4.10.1.1 Removal.
To prevent rolling or sliding, do not work on equipment that is not
securely stabilized.
Ensure both wheels are secure.
Do not touch exhaust system after equipment operation.
Exhaust systems
become very hot and can cause serious burns.
Failure to obey these warnings may result in serious personal injury.
a.
Remove five nuts (figure 4-4, 1), one post (2) and six washers (3) that secure
muffler (4) to engine.
Retain all parts removed.
b.
Carefully remove muffler (4) from studs.
c.
Remove and discard three gaskets (5).
4.10.1.2 Disassembly.
a.
Loosen nut (figure 4-4, 6), lockwasher (7) and bolt (8) that secures
clamp (9).
b.
Remove exhaust pipe (10) and clamp (9) from muffler (4).
4.10.1.3 Repair.
a.
Inspect muffler for holes or cracks.
b.
Check to ensure internal components are not burned out.
c.
Replace any damaged or missing parts.
4.10.1.4 Reassembly.
a.
Position clamp (9) over the muffler (4) and position open end of exhaust pipe
upward.
b.
Install exhaust pipe (10) into muffler (4) and position as shown.
c.
Tighten nut (6) until exhaust pipe (10) is secure.
4.10.1.5 Installation.
a.
Install three gaskets (5) over studs.
b.
Carefully install muffler (4) over studs with exhaust pipe.
c.
Install six lock washers (3), five nuts (1) and one post (2) and tighten.
4-16
