4.10.3.4.3. Installation. (Refer to Figure 4-6.1)
a.
b.
C.
d.
e.
f.
g,
h.
N O T E
The blockor has left hand threads.
Install blockor (5) in bottom of valve assembly(3).
Position valve assembly(3) on side of engine and secure with flat washers (18), lockwashers (17)
and screws (16).
Secure terminal ring(15) to engine block.
Install temperature switch(9) on side of engine with screw(13), and flat washer(14).
Install new connector(11) on wire(12) and secure terminal ring(10) onto starter solenoid.
Install new connecters(7) on wire(8) between temperature switch(9) and valve assembly(3).
Install atomizer(6) into engine manifold and connect tubing(4) to blocker(5).
Install a serviceable can of starting fluid(2) in valve assembly(3) and tighten clamp(l).
Figure 4-6.1. Starting Aid Solenoid Maintenance (Model 350 PAWN).
4-20.2 Change 2
