TM 10-4320-226-144.10.4.3.Cold Start Aid Nozzle Maintenance (Used on Model 350 PAWN)This task covers:4.10.4.3.1Removal4.10.4.3.2 InstallationINITIALSETUPToolsGeneralSafetyInstructionsGeneral Mechanic’s Tool Kit (Appendix B, Section III,Item 1)To prevent rolling or sliding, do not work on equipmentthat is not securely stabilized.EquipmentConditionsEquipment shut down, paragraph 2.5.2.Do not work on equipment without following standardshop safety precautions.4.10.4.3.1.Removal.(Refer to figure 4-6.3)a.Unscrew nut of tubing (1) from nozzle (2).b.Remove nozzle (2) from intake manifold (3) of engine.4.10.4.3.2. installation.(Refer to figure 4-6.3)a.Install nozzle (2) on manifold (3) of engine in a manner that blue dot on nozzle is positioned to the left of the installerand is tight. When installed this will inject starting fluid into the manifold against the air stream for optimumatomization.b. Connect tubing (1).Figure 4-6.3. Starting Aid Nozzle Maintenance (Model 350 PAWN).Change 2 4-21
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
