TM5-4930-230-13
1. SCREEN
2. EYENUT
3. SETSCREW (2)
4. BONNET
5. SPRING
6. STEM
7. RETAINER
8. DISK
9. NUT
10. VALVE BODY
Figure 5-13. Dispensing Valve,
5-13. TANK ASSEMBLY: GENERAL
The tank and its components (figure 5-14) must be cleaned before any repair is initiated. Each time a
component is removed for repair, inspection, or other service; it must be cleaned thoroughly. Make
certain every safety precaution is taken prior to attempting any repair on a tank. Areas of the tank to be
subjected to severe heat must be cleaned to the bare metal. Use a stiff, stainless steel, wire brush or
other suitable tool for this purpose. Pay particular attention to
tends to volatilize tetraethylene deposits, causing toxic fumes.
the seams; heat from a welding torch
5-28
