TM 5-4930-230-13b. Disassembly. (figure 5-11)(1) Remove nuts (1), lockwashers (2), flat washers (3), and screws (4) attaching strap fastener loop(5) to frame.(2) Remove strap (6) and gasoline can (7).(3) Rivets (8) attach latch (9) to storage box (18). They are not removed unless necessary for repairor replacement of damaged parts.(4) Rivets (10) attach strike (11) to door (15). They are not removed unless necessary for repair orreplacement of damaged parts.(5) Rivets (12) attach hinge (14) to door. They are not removed unless necessary for repair orreplacement of damaged parts.(6) Rivets (13) attach hinge to storage box. They are not removed unless necessary for repair orreplacement of damaged parts.(7) If necessary, remove rubber seals (16 and 17) from opening of storage box.(8) The brass bearings (19) in inner A-frames, and ball bearings (20) in outer A-frames are pressedin. To replace, knock defective bearing out of A-frame and press in new bearing.c. Cleaning, Inspection, and Repair.WARNINGDrycleaning solvent. P-D-680, used to clean parts is potentially dangerousto personnel and property. Avoid repeated and prolonged skin contact. Donot use near open flame or excessive heat. Flash point of solvent is 100degrees F - 138 degrees F (38 degrees C - 59 degrees C).(1) Clean parts with drycleaning solvent (Item 1, App. E) and dry thoroughly.(2) Inspect for damaged or defective parts.(3) Repair or replace defective parts.(4) If necessary to weld frame, make certain the frame is free of dirt, oil, grease, or other foreignmatter, and bare metal is exposed for welding.NOTEThe reel bearing in each inner and outer A-frame is pressed in. To replace,knock defective bearing out of A-frame and press in new bearing.d. Reassembly. (figure 5-11)5-21
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business