TM 5-4320-302-14
6-17.
CONNECTING ROD ASSEMBLY (CONT)
Location/Item
Action
Remarks
REASSEMBLY
24. Connecting
If connecting rod has been replaced, clamp new
rod and small-
connecting rod into padded vise and pull in
end bush
small-end bush with piston pin bush inserter
No. 131310.
25. Connecting
If connecting rod and/or big-end bearings
Install new hex
rod, big-end
have been replaced, matchmark connecting
bolts.
bearing, and
rod, bearings, and bearing cap with one mark
bearing cap
for cylinder No. 1 and two marks for cyl-
inder No. 2. Always use new hex bolts for
installation of connecting rod and bearings
onto crankpin on crankshaft.
6-138
