TM 5-4320-302-14
5-5. BEARING HOUSING ASSEMBLY (CONT)
Location/Item
Action
Remarks
12. Shaft
Inspect shaft for excessive wear, rust, corrosion,
or other damage. Replace shaft if damaged.
ASSEMBLY
13. Ball bearing
Apply coating of MIL-T-22361 thread com-
pound to inside diameter of bearing. Press onto
shaft from engine end.
14. Shielded
Press onto shaft from pump end with loading
double row
notch toward keyway slot and away from pump
bearing
end of shaft.
15. Snap ring
Install into ring groove on shaft.
16. Lip seal
Press a replacement lip seal into the bearing
housing assembly. Install with lip toward engine.
17. Shaft
Press shaft with bearings and snap ring into
bearing housing from pump end.
18. Grease seal
Press a new grease seal into bearing cap. Install
with lip toward pump end.
19. Bearing cap
Install with new grease seal. Slide in onto shaft,
and install lockwashers and hex head cap screws.
Tighten hex head cap screws securely.
5-19
