TM 5-4320-302-145-4. PUMP AND BEARING HOUSING ASSEMBLY (CONT)Location/ItemActionRemarks36. Tapered hubInstall tapered hub on shaft, alining keyway inhub with key on shaft.37. Flex disca. Install flex disc over shaft and onto tapered hub.b. Install cap screws fingertight.38. Tapered hubUsing previously recorded dimension, positionand flex disctapered hub and flex disc assembly on shaft.assemblySecure in place by tightening cap screws in across pattern.WARNINGMake sure that hoists and other lifting equipment are ingood repair and of sufficient capacity to safely handleloads without injury to personnel or damage to equipment.Securely attach lifting equipment. Before lifting, be sureload is balanced.39. Pump andPosition a suitable lifting device equipped with aSpread slings onbearing hous-spreader bar and slings over pump and bearingspreader bar so thating assemblyhousing assembly. Attach slings around assemblyslings hang verticallyand put tension on slings. Make sure assemblywhen attached tois properly supported.assembly.40. Pump andLift and remove frombearing hous-blocks on work plat-ing assemblyform. Lower carefullyso that bearing hous-ing assembly alineswith engine adapterhousing. Aline holes inflex disc with drivepins on drive ring, andpump mounting studs inpump mounting angle.When these holes andpins are alined, slidepump and bearing hous-ing assembly towardengine so that this disccoupling mates andengages properly.NOTEAlinement of the flex disc and drive ring may be checkedand corrected by viewing through flywheel guard.5-14
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business