TM 5-4320-302-14 5-7.  ENGINE ASSEMBLY This task covers: a.  Removal b.  Installation/Replacement INITIAL SETUP Tools 4-16 Control panel cover assembly removed.  Cables and hoses re- Shop set, automotive repair, moved from engine side only. field maintenance, basic NSN 4910-00-754-0705 4-18 Exhaust primer assembly re- moved (as a unit). Tool kit, master mechanics NSN 5180-00-699-5273 4-20 Exhaust elbow and guard Materials/Parts removed. Engine assembly 4-21 Air intake system removed (as a unit). Equipment Condition 4-22 Fuel tank lines and fittings Para Condition Description removed. 4-14 Battery box assembly removed. 5-4 Pump and bearing housing 4-15 Electrical system removed from assembly removed. engine side only. Location/Item Action Remarks REMOVAL WARNING Make sure that hoists and other lifting equipment are in good repair and of sufficient capacity to safely handle loads without injury to  personnel or damage to equipment. Securely attach lifting equipment to engine assembly. Before lifting, be sure load is balanced. CAUTION Engine damage will occur if engine is set on bottom cover. Provide adequate blocking to support engine after removal from skid assembly. 1.  Engine a.  Position a suitable lifting device equipped Spread slings on assembly with a spreader bar and slings over engine spreader bar so that assembly.  Attach slings to lifting bracket slings hang vertically and around engine assembly.  Put tension on when attached to slings.  Make sure engine is properly supported. engine assembly. 5-24