TM 5-4320-302-14
4-38. ALTERNATOR (CONT)
Location/Item
Action
Remarks
INSTALLATION/
REPLACEMENT
7. Alternator
If replacement alternator and voltage regulator
and voltage
are supplied with new mounting hardware, dis-
regulator
card old hardware. Install voltage regulator on
alternator, if necessary. Aline alternator with
blower jacket mounting hole.
8. Alternator
Support alternator and secure with blower
jacket screw, damping bushes, washers, and nut
to blower jacket. Tighten nut only hand tight.
9. Clamping plate
Install clamping plate on alternator with clamping
plate screw, washers, rubber pads, and nut.
Tighten nut only hand tight.
10. Alternator
Install ground wire with ground wire screw and
washer. Tighten screw only hand tight.
11. Alternator
Install in accordance with paragraph 4-28.
V-belt pulley
and fan
12. V-belts
Install in accordance with paragraph 4-27. Adjust
V-belt tension in accordance with paragraph 4-27.
13. V-belt guard
Install V-belt guard in accordance with para-
graph 4-26.
14. Alternator wires
Connect in accordance with paragraph 4-15.
SYSTEM TEST
WARNING
Carbon monoxide is produced by the internal combustion
engine of this pump. Death may result if personnel fail to
observe safety precautions.
Carbon monoxide is a colorless, odorless, deadly poisonous
gas which, when breathed, deprives the body of oxygen and
causes suffocation. Exposure to air contaminated with car-
bon monoxide produces symptoms of headache, dizziness, loss
of muscle control, or apparent drowsiness. Coma, permanent
brain damage, or death can result from severe exposure.
4-180
