TM 5-4320-300-14
6-13. WATER PUMP (CONT)
Location/Item
Action
Remarks
REASSEMBLY
14. Pump body
Position with cover side down on a solid block
of wood.
CAUTION
Bearing damage may occur if pump is assembled by pushing on. end of pump shaft.
15. Bearing and
Position at opening on top of pump body.
shaft
Apply pressure to outer bearing race until
assembly
it is flush with outer face of pump body.
16. Seal assembly
Lightly coat outside diameter of new seal
Properly installed
assembly with MIL-S-45180 sealing compound.
flange should con-
Support face of body and outer race of bearing.
tact pump body.
Apply pressure to seal outer flange and install
seal assembly. Remove dirt and metal particles
from face of seal with lint-free cloth.
17. Impeller
Position pulley end of shaft on bed of an arbor
press. Push impeller on shaft until impeller is
flush with cover end of pump body.
6-123
