CRANKSHAFT AND FLYWHEEL (CONT) - TM-5-4320-300-14

CRANKSHAFT AND FLYWHEEL (CONT) - TM-5-4320-300-14_483

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
475

6-11. CRANKSHAFT AND FLYWHEEL (CONT)) Location/Item Action Remarks 20. Oil seal Install oil seal sleeve on front (engine cover) sleeve on contact surface as follows: engine cover surface a. Stone high spots from oil seal contact sur- face of crankshaft. b. Coat contact surface with MIL-T-22361 thread compound. c. Position sleeve on crankshaft with radius on sleeve facing away from engine. d. Drive sleeve squarely on shaft. e. Wipe off any excess sealant. f. Coat the outside diameter of sleeve with MIL-L-2104 oil. NOTE To remove a worn sleeve, peen the outside diameter of sleeve until it stretches sufficiently so it can be slipped off end of crankshaft. 21. Oil pump Check for worn or chipped teeth. Replace gears, drive gear and if necessary. timing gears 22. Thrust surfaces Check for wear or grooving. If only slightly worn, dress surfaces with a stone. Regrind the thrust surfaces if excessively worn or grooved. 6-98

Privacy Statement
Press Release
Contact