INSTALLATION OF CYLINDER BLOCK END PLATE

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
423

TM 5-4320-300-14 6-7. CYLINDER HEAD AND BLOCK (CONT) Location/Item Action Remarks 66. Cylinder block Install any removed plugs and dowels prior to plugs and installation of other engine components. dowels 67. Cylinder block Check all machined surfaces and threaded holes final check for nicks and burrs. 68. Preparation If block is not to be used immediately, spray for storage machined surfaces with MIL-L-2104 oil. If block is to be stored for an extended period of time, spray or dip in QPL-10036-10 rust arresting coating. INSTALLATION OF CYLINDER BLOCK END PLATE 69. Cylinder block Position a new gasket on the end of the cyl- Ensure that all traces end plate inder block, and secure it with MIL-S-45180 of old gasket mate- gasket sealing compound. Apply a coating of seal- rial has been removed. ing compound to outer side of gasket. 70. Cylinder block Aline dowel pin holes in end plate with dowel end plate pins in cylinder block. Push end plate over pins and up against cylinder block. 71. Mounting Install. Torque bolts to 30 to 35 ft lb (41 to bolts and 47 N•m). lockwashers 6-46

Privacy Statement
Press Release
Contact