TM 5-4320-300-14
6-7. CYLINDER HEAD AND BLOCK (CONT)
Location/Item
Action
Remarks
REASSEMBLY OF
CYLINDER HEAD
39. Valves
Install in accordance with paragraph 6-9.
WARNING
Severe burns, illness, or death may result if personnel fail to handle diesel fuel
properly. Observe the following precautions:
·
Do not inhale vapor.
·
Do not handle near open flame, sparks, or excessive heat.
·
Be certain fuel lines and connections are secure.
·
Work in a well-ventilated area.
40. Injectors
Fill each injector with clean VV-F-800 diesel
fuel until it runs out of filter cap. Insert in-
jector into injector tube in cylinder head.
NOTE
Be certain the dowel in injector body registers with locating hole in cylinder head.
41. Push rod
Position lower spring seat, spring, upper spring
Lower spring
assembly
seat, and lock nut on the push rod. Install
seat is serrated;
spring retainer in cylinder head. Slide push
upper spring
rod assembly into place from bottom of cyl-
seat is cup
inder head.
shaped.
6-37
