ASSEMBLY - TM-5-4320-300-14

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
386

TM 5-4320-300-14 6-4. BLOWER ASSEMBLY (CONT) Location/item Action Remarks ASSEMBLY CAUTION Equipment damage may occur through low oil pressure if front and rear plates are mixed during assembly. The rear plate does not have tapped holes for the thrust washer bolts or holes for thrust washer lubrication. 14. Front and Place plate on an arbor press. Lubricate inner and rear plate outer diameter of seals with MIL-L-2104 oil and oil seals press seals (lip facing down) into place in counter- bored hole. 15. Rotor Place front plate on two wood blocks. Install assemblies rotor assemblies gear end up, on plate. 16. Housing Remove any foreign material from inner surface assembly and install over rotor assemblies. Install over rotor rear plate assembly shafts. Secure to housing assembly with screws. Install two cover bolts and plain washers. 17. Thrust washers Install screws on front plate. Mount thrust washers and front plate by threading bolts into rotor shaft. Torque bolts screws to 54 to 59 ft lb (73 to 80 N.m). 6-9

Privacy Statement
Press Release
Contact