Section II. MAINTENANCE PROCEDURES - TM-5-4320-300-14

General Support Maintenance Troubleshooting - Continued

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
382

TM 5-4320-300-14 Section II. MAINTENANCE PROCEDURES INDEX Para Para Bearings 6-12 Oil pump 6-6 Blower assembly 6-4 Pistons and connecting rods 6-10 Crankshaft and flywheel 6-11 Radiator 6-14 Cylinder head and block 6-7 Valves, camshaft, and Cylinder liner 6-8 timing gears 6-9 Oil cooler 6-5 Water pump 6-13 6-3. GENERAL INSTRUCTIONS Most maintenance instructions in this section will list resources required, personnel required, and equipment condition for the start of the procedure. Note the following: Resources required are not listed unless they apply to the procedure. Personnel required are listed only if the task requires more than one. If PERSONNEL is not listed, it means one person can do the task. The normal standard equipment condition to start a maintenance task is engine stopped and battery disconnect switch off. EQUIPMENT CONDITION is not listed unless some other condition is required besides the power being off. 6-5

Privacy Statement
Press Release
Contact