TM 5-4320-300-14
5-12.
FUEL INJECTORS (CONT)
Location/Item
Action
Remarks
3. Crankshaft
Rotate crankshaft with starter motor to depress
exhaust valves on each side of the injector to be
timed.
4. Injector body
Adjust timing gage for a timing dimension of
1.460 inches (37.084 mm). Place small end of in-
jector timing gage in the hole in the top of the
injector body. Turn the flat of the gage toward
injector follower.
5. Push rod
Loosen injector rocker arm push rod lock nut.
and injector
Turn push rod and adjust injector rocker arm
rocker arm
until extended part of gage will just pass over
the top of the injector follower. Hold push rod
and tighten lock nut. Check adjustment (gage
will just pass over the top of injector follower).
If necessary, readjust push rod. Time remaining
injectors in the same manner.
5-37