INSTALLATION - TM-5-4320-300-14

TM-5-4320-300-14 Pump Centrifugal Self-Priming Gasoline Engine Driven; 6-Inch 1500 GPM Capacity At 60 Foot Head Manual
Page Navigation
281

TM 5-4320-300-14 4-46. SPRINGS (CONT) Location/Item Action Remarks 2. Frame Position jack under frame between wheel to be raised and wheel chock. Jack up frame enough to relieve tension on spring (usually just as wheel clears ground) and place jack stands under frame. Put a wood block under front leg if nec- essary, to further support trailer. The jack may have to be raised slightly to accomplish this. 3. Rear stand Lower and pin rear stand if possible on same side. 4. Springs Loosen nuts on U-bolts securing spring to axle. If much tension is noticed, adjust jack and jack stand support height to lessen tension. Re- move nuts and shackle. Remove spring bolts and nuts. Remove spring. INSTALLATION 5. Spring Position replacement spring and install spring bolts and nuts. Tighten securely. Install U-bolts from the bottom side of the axle, and install shackle and mounting nuts. Tighten securely. 6. Rear stand If rear stand was raised on same side, remove pin. 7. Front leg Remove wood block from under front leg if necessary. Raise jack enough to remove jack stands. 8. Trailer Lower trailer to ground. 4-185

Privacy Statement
Press Release
Contact