TM 5-4320-300-144-4. AXLE, WHEELS, AND TIRES (CONT)Location/ItemActionRemarks16. BearingsPack bearings about 1/3 full of MIL-G-10924grease, and install them in the hubs. Take careto avoid damaging lips of grease seal when in-stalling hub on axle. Install washers and nutson axle. Tighten nuts slightly to seat the bear-ings. Then, back off the nuts and tighten themhand tight.17. Wheels Reinstall flaps on wheels and put tubes intotires. Place tires on wheels and inflate to 45 psi(310.3 kPa) maximum. Mount wheels on hubsand install wheel rim cap screws hand tight.Spin the wheels and hand adjust the axle nutsuntil the wheels spin freely but without anylooseness on the axle. Insert cotter pins andbend over to lock nuts in position. Drive greasecups onto hubs. Tighten cap screws evenly andalternately.18. FrameJack up each side of frame in turn and removejack stands. Remove wood blocks from underfront leg. Re-level rear stands ONE AT A TIME.Again tighten cap screws evenly and alternately.4-181
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
