TM 5-4320-300-14
4-13. AIR CLEANER ASSEMBLY (CONT)
Location/Item
Action
Remarks
6. Air cleaner
Place air cleaner under straps of mounting band.
assembly
Install clamp screws and nuts. Position cleaner
inlet straight up. Tighten clamps securely.
7.
Air inlet hood
Fit hood outlet over cleaner inlet. Press down on
hood to mate tapers.
8.
Elbow
Place clamps over elbow. Place ends over
cleaner outlet and inlet pipe. Slide clamps to
ends of hose. Position clamps for easy access.
Tighten clamps securely.
9.
Restriction
Apply 1/2-inch (5.08 cm) Teflon tape (MIL-T-
indicator
27730) to male pipe threads prior to assembly.
Install elbow into air inlet housing, tighten, and
position for easy installation of hose. Install hose
into elbow and tighten. Install elbow on free
end of hose and tighten; position elbow to line
up with hole in bottom of control panel. Install
washers on either side of panel bottom. Install
nipple, through washers and panel bottom, into
elbow and tighten. Install indicator onto nipple
and tighten. Reset indicator by pushing down
button on its top.
4-83
