TM 5-4320-300-14 Section V.  MAINTENANCE PROCEDURES INDEX Para Para Air cleaner assembly 4-13 Main wiring harness 4-22 Air shutdown solenoid 4-25 Muffler 4-17 Alternator assembly 4-20 Oil filter 4-33 Alternator and fan drive belts 4-23 Oil lines, fittings, and oil pressure Atomizer 4-32 gage tube assembly 4-35 Axle, wheels, and tires 4-44 Radiator 4-38 Battery box and cover assembly, Shock absorbers 4-47 battery, and cables 4-19 Speed regulating throttle cable 4-24 Blackout stoplights 4-48 Springs 4-46 Control panel assembly, instruments, Starter motor assembly 4-21 and switches 4-41 Starting aid control cable 4-30 Cooling fan 4-36 Suction and discharge companion Companion (coupling) flanges, (coupling) flanges 4-40 suction and discharge 4-40 Switches 4-41 Drive belts, alternator and fan 4-23 Taillight and blackout stoplights 4-48 Ether cylinder 4-31 Thermostat 4-39 Exhaust heat shield 4-14 Throttle cable 4-24 Exhaust manifold pipe 4-18 Time delay relay 4-42 Exhaust pipe 4-16 Tires 4-44 Fan, cooling 4-36 Trailer assembly and frame 4-43 Frame assembly 4-43 Trailer wiring harness 4-45 Fuel injectors 4-29 Water pump 4-37 Fuel lines, hoses, and fittings 4-27 Weather cap 4-15 Fuel strainer and filter 4-28 Wheels 4-44 Fuel tank 4-26 Wiring harness Inspection 4-12 Main 4-22 Instruments 4-41 Trailer 4-45 Low oil pressure cutout switch 4-34 4-11.  GENERAL INSTRUCTIONS Maintenance instructions in this section will list resources required, personnel required, and equipment condition for the start of the procedure.  Note the following:   Resources required are not listed unless they apply to the procedure.   Personnel required are listed only if the task requires more than one.  If PERSONNEL is not listed, it means one person can do the task.   The normal standard equipment condition to start a maintenance task is engine stopped and battery disconnect switch  off.    EQUIPMENT  CONDITION  is  not  listed  unless  some  other  condition  is  required  besides  the  power being off.   Refer  to  Appendix  F  to  determine  torque  requirements  when  tightening  threaded  fasteners,  unless  a  specific torque value is given in procedure.  Standard torque values given in Appendix F are determined by thread size. 4-77