TM 5-4320-275-13 & P
GEAR REDUCER (CONT)
LOCATION/ITEM
ACTION
REMARKS
INSTALLATION
6. Gear reducer
Set gear reducer (6) on
frame. Slide gear reducer
shaft into crank. Align
four screw holes in gear
reducer and frame.
7. Cap screws
Use Loctite on screw threads. Use 15/16 inch
and nuts
wrench to hold nuts (2). Use 15/16 inch socket
and handle to install two cap screws (1). Install
nuts (2) and lockwashers (3).
NOTE
Do not tighten.
8. Cap screws
Use Loctite on screw threads. Use 15/16 inch
closest to
socket and handle to install two cap screws (4).
crank
Install lockwashers (5).
NOTE
Do not tighten.
9. Tighten cap
Use 15/16 inch socket with a torque wrench to
screws
tighten cap screws (1, 4, and 7) to a torque of
75 ft lb (102 Nm).
4-83
