TM 5-4320-200-13 & P
c.
Repair.
Refer to Direct Support Maintenance.
d.
Installation.
(1) Refer to figure 4-3. Repeat the removal procedures in
reverse sequence.
4-2.6. Conversion Engine Model 1A08-1 to Model 1A08-3.
When the Model 1A08-1 engine is replaced with a Model 1A08-3
engine the following changes are required.
a.
Engine mounting. The rails used to mount the 1A08-1 engine
are made with the brackets as an assembly. The rails used to mount
the 1A08-3 engine are separate from the brackets. When replacing the
1A08-1 with a 1A08-3 model, requisition the rails and brackets for
installation. The brackets used for mounting the 1A08 engine will fit
any Military Standard engine.
When the engine is replaced the fuel system
must also e rep aced. The items to be replaced are as shown in
figure 4-4 and are as follows:
1 - Bracket
2 - Fuel line
3 - Fuel tank
NOTE
The existing fuel tank can be used with a
possible modification of the bracket.
4 - Fuel filter.
Refer to Appendix D for part numbers.
4-3. ELECTRIC MOTOR DRIVE in PUMP.
4-3.1. Power Cord.
a.
Removal.
(1) Refer to figure 4-5. Remove screws (1) that attach
connection box cover (2) to motor (3).
(2) Disconnect power cable (4) from wires (5) inside connec-
tion box.
(3) Loosen connector (7) and remove cable (4).
4-8
Fuel System.