TM 5-3825-270-23&P
FIELD MAINTENANCE
ENGINE MODULE REPLACEMENT
INITIAL SETUP:
Materials/Parts (cont.)
Tools and Special Tools
Isolator Mounts (WP 0226, Table 1, Item 49)
Tool Kit, General Mechanic's: Automotive
Qty: 4
(WP 0225, Table 1, Item 12)
Locknut (WP 0226, Table 1, Item 41) Qty: 4
Jack, Hyd Hand Bottle, Type 20 Ton Cap
Locknut (WP 0226, Table 1, Item 66) Qty: 2
(WP 0225, Table 1, Item 2)
Multi-Leg Nylon Sling (WP 0225, Table 1, Item 3)
Shakle (2) (WP 0225, Table 1, Item 7)
Personnel Required
Lifting Device, Minimum Capacity 800 lbs
Construction Equipment Repairer 91L (2)
Wrench, Torque, 50-250 lb-ft (68-339 Nm), 1/2 in.
Drive (WP 0225, Table 1, Item 15)
Wrench, Torque, 40-200 lb-in (6-23 Nm), 3/8 in.
References
Drive (WP 0225, Table 1, Item 14)
Parts Manual (WP 0220) Figure 4007
Tap & Die Set (Screwdriver) (WP 0225, Table 1,
Parts Manual (WP 0220) Figure 4020
Item 2)
Parts Manual (WP 0220) Figure 4024
Parts Manual (WP 0220) Figure 4037
Materials/Parts
Tags, Identification, White (WP 0224, Table 1, Item
Equipment Condition
54)
Batteries disconnected. (WP 0085)
Cable Ties (WP 0224, Table 1, Item 9)
Engine compartment cover removed. (WP 0142)
Lumber, Softwood, Dimension (WP 0224, Table 1,
Item 41)
REMOVAL
NOTE
Remove cable ties and retainers as required.
Tag and mark wires prior to removal to ensure proper installation.
Note wire harness routing prior to removal to ensure proper installation.
Only positive battery cable needs to be removed from starter, all other wires remain on
starter.
1.
Remove nut (Figure 1, Item 1) and positive battery cable (Figure 1, Item 6) from starter (Figure 1, Item 2).
0128-1