TM 5-3820-276-10-2
OPERATOR MAINTENANCE
WHEEL AND TIRE ASSEMBLY REPLACEMENT - MUD CLEANING SYSTEM (MCS) AND PORTABLE AIR
COMPRESSOR (PAC)
INITIAL SETUP:
Tools and Special Tools
Tools and Special Tools (cont.)
Adapter, 1/2-in. X 3/4-in.
Socket, 27-mm X 1-in. (WP 0231, Table 2, Item
(WP 0231, Table 2, Item 1)
20)
Extension, 1-in. X 6-in.
Wrench, Torque 1/2-in. Drive
(WP 0231, Table 2, Item 6)
(WP 0231, Table 2, Item 27)
Gauge, Tire Pressure
(WP 0231, Table 2, Item 8)
Personnel Required
Handle, Extension (WP 0231, Table 2, Item 11)
Two
Handle, Lug Wrench (WP 0231, Table 2, Item 12)
Jack, Hydraulic, 8-Ton
(WP 0231, Table 2, Item 13)
References
Multiplier, Torque, Gear Ratio 3 to 1
Volume 1, WP 0015
(WP 0231, Table 2, Item 14)
Volume 1, WP 0050
Reflector Set, Highway Warning, Triangular
Volume 1, WP 0059
(WP 0231, Table 2, Item 16)
Socket, 1-1/8-in. X 1-1/16-in. (WP 0231, Table 2,
Item 19)
SETUP FOR MCS
WARNING
Park equipment in safe area, out of traffic, where there is no danger to personnel changing
tire assembly. Park equipment on hard level ground. Failure to comply may result in injury
or death to personnel. Seek medical attention in the event of an injury.
NOTE
Make sure MCS is parked on a level surface before performing wheel and tire assembly
replacement.
1.
Set up highway warning reflector set, as required.
2.
Position wheel chocks to tires on opposite side of MCS of tire assembly that will be
replaced (Volume 1, WP 0015).
3.
Shut down MCS engine (Volume 1, WP 0050), if required.
END OF TASK
0207-1
02/13/2013root(maintwp)wpno(M00010)