c. Disassembly (Model 36W50)

Figure 5-14. Hose Reels, Disassembly and Reassembly (All Models Except 36W50).

Figure 5-15. Hose Reel, Disassembly and Reassembly (Model 36W50)

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
153

TM 10-4930-204-13 c. Disassembly (Model 36W50). (1) Remove spring housing assembly (1, fig. 5-15), nuts (2) bolts (35), roller bracket (3), outer side plate (4), and bushing (5). (2) Remove nut (6), washer (7), capscrews (8 and 9), and spacer (10). (3) Remove setscrew (11) and outer flange (12). (4) Remove hub (13) and spacer (14). (5) Disconnect pipe assembly (15) and O-ring (16) from adapter (18). (6) Remove ball bearings (17) from adapter (18). Remove adapter, bearing (19), and spacer ring (20), from pipe assembly (26). (7) Remove nut (21), washer (22), inner side plate (23) and bolt (24) from inner flange (25). (8) Remove pipe assembly (26) from flange. Remove key (27) from pipe. (9) Remove cotter pin (28) and bearing retainer (29) from pipe (15). (10) Remove cotter pin (30), washer (31), pawl (32), pawl stud (33), and self-locking nut (34). d. Cleaning, Inspection, and Repair (All Models). Drycleaning solvent normally has a flash point of either 100 or 138 degrees F, depending on the type being used, but may flash at much lower tem- peratures if contaminated with gasoline or jet fuel. Avoid repeated and prolonged skin contact. Do not use near open flame or excessive heat. (1) Clean parts with drycleaning solvent (item 1, App. F) and dry thoroughly. (2) Inspect and other damage. (3) Inspect (4) Inspect spring housing for cracks, breaks, distortion reel for dents or distortion. ratchet wheel for damage or defects. 5-32

Privacy Statement
Press Release
Contact