TM 10-4930-204-13c.Reassembly andInstallation.(1) Install gasket (12, fig. 5-16) and manhole cover (11)and secure by attaching lug (15), washer (16), wingnut (17) and cotterpin (14) to bolt (13).(2) Install spring (8), latch lock (7), latch (6), fillerplug (3), and secure with capscrews (9) and capscrew nuts (10).(3) Lift filler plug and install cover gasket (5) and ventassembly (4).(4) Attach vent body cap (2) to filler plug and secure withscrews (1).5-27.PUMP PORT.a.RemovalandDisassembly.(1) Remove manhole cover (para 5-26).(2) Remove dipstick (1, fig. 5-17) and tube (2).(3) Remove locknut (3), strainer screen (4) and strainercasting (5) from bottom of tank assembly.b.Cleaning andInspection.(1) Clean dipstick with soap and water and dry.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin contact.Do not use near open flame or excessive heat.(2) Clean remaining parts with cleaning solvent (item 1,App. F).Immerse each part in solvent and remove contaminants bybrushing.Allow parts to dry thoroughly.(3) Inspect all parts for damage or defect. Replacedamaged or defective parts.(4) Coat parts with a thin film of light lubricating oil(item 5, App. F) before assembly.c.Reassembly andInstallation.(1) Position strainer casting (5, fig. 5-17) in bottom oftank.Install strainer screen (4), and secure with locknut (3).5-37
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
