5-23. FUEL DISPENSING HOSE REEL ASSEMBLY.

Figure 5-13. l7. Bonding wire 18. Clip 19. Nozzle body nut Nozzle, Disassembly and Reassembly.

Figure 5-14. Hose Reels, Disassembly and Reassembly (All Models Except 36W50).

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
151

TM 10-4930-204-13 (7) Replace damaged or defective parts. d. Reassembly. (1) Attach clip (18, fig. 5-13) to bonding wire (17) and connect assembly to nozzle body (19). (2) Install cap, chain and spring (16). (3) Install packing (15), packing gland nut (14), and packing nut (13). (4) Insert screen into spout and spout (12) into nozzle body (19) and tighten as necessary. NOTE Ensure spout is properly attached to nozzle body to avoid leakage during operation. (5) Install stem (11), disk retainer nut (10), disk retain- er (9), lower disk (8), dash pot (7), upper disk holder (6), upper disk (5), upper disk nut (4), spring (3), gasket (2), and bonnet (1). e. Installation. Install nozzle assembly (para 4-31). 5-23. FUEL DISPENSING HOSE REEL ASSEMBLY. a. Removal. Remove hose reel assembly (para 4-32). Do not disassemble spring housing assembly. The spring is under tension and can cause serious injury or even death if disassembled improperly. Repair of spring housing assembly is by replace- ment only. b. Disassembly (All Models Except 36W50). (1) Remove spring housing assembly (1, fig. 5-14), bushing (2), nut (3), lockwasher (4), side plate (5) and roller bracket (6). (2) Remove bolt (7) and (3) Remove capscrew (9) (4) Remove nut (11) and (25). ratchet wheel (8) from flange (10). and flange (10). washer (12) from spacer spindle (5) Disconnect coupler elbow (13) from pipe (14); remove pipe from hub (26). 5-30

Privacy Statement
Press Release
Contact