TM 10-4930-204-13Figure 5-10.2 Adapter Shaft Seal Assembly.(5) Using Lubricating Oil (Appendix F, Item 3), lubricate and install O-Ring packing(12, Figure 5-10.1) ontowear plate (11).(6) Install wear plate (11) and screws (10). (Inspect for bent or defective baffle on back side of wear plate).(7) Install shims (9) as required to maintain impeller-to-wear plate clearance at 0.010 to 0.015 inch (0.025 to0.038CM),(8) Install impeller (8) new retaining packing (7) and center screw (6).(9) Lubricate and install O-Ring (5), volute (4) and fasten with washer (3) and nut (2).(10) Connect inlet elbow, discharge elbow, and priming port.(11) Install pump drain plug (1).e. Installation. Install Electric Motor Driven Pumping Assembly (para. 4-24.1).5-20. FILTER/SEPARATOR.a. Removal.Remove the filter/separator (para. 4-27).b. Diaassembly.(1) Remove nut (1, fig. 5-11), washer (2), bolt (3), coupling half (4), cover (5), and gasket (6) from filter shell (25).(2) Remove wing nut (7), washer (8), and retainer (9) from rod (12).(3) Remove canister (10) and element (11).5-22.4Change 4
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business