TM 10-4930-204-13
(5) Insert screwdriver in slot at end of motor shaft to
prevent rotation.
Install impeller and impeller nut on shaft (fig.
5-10).
(6) Position vane plate; fasten three machine screws
securing vane plate to intermediate.
Use sealant (item 7, App. F)
between vane plate and intermediate.
(7) Position gasket and
fastening eight nuts securing body
(8) Secure drainplug.
attach body to intermediate by
to intermediate.
(9) After reassembly, adjust position of support bolt to
support end of motor.
LOCKNUT
Figure 5-10.
Centrifugal Pump, Seal and Impeller Installation.
5-21
