TM 10-4930-204-13
(4) Remove rod (12) and nut (13).
(5) Remove bushing (14) and plug (15). Remove gages (16).
(6) Remove valve (17), rod (18), glass (19), and valve (20).
(7) Remove hose (21), clamp (22), cock (23), and elbow (24).
c. Cleaning and Inspection.
WARNING
Drycleaning solvent normally has a flash point of either 100 or
138 degrees F, depending on the type being used, but may
flash at much lower temperatures if contaminated with gasoline
or jet fuel. Avoid repeated and prolonged skin contact. Do not
use near open flame or excessive heat.
(1) Clean parts with drycleaning solvent (item 1, App. F) and dry thoroughly.
(2) Flush the interior of the filter/separator with drycleaning solvent and dry thoroughly.
(3) Inspect filter elements and gaskets for serviceability. Replace gaskets. Filter elements can be reused if
serviceable.
(4)
(5)
Inspect filter/separator for distortion, broken welds, dents, or other damage.
Inspect sight window for cracks, breaks, and transparency. Inspect ball for damage.
Change
5
5-22.5/(5-22.6
Blank)
