5-16. CAMSHAFT AND GOVERNOR ASSEMBLY.

Figure 5-7. Crankshaft, Disassembly and Reassembly.

Figure Expansion plug (3) Camshaft support pin Governor spacer Bearing sleeve Camshaft Spring pin, 3/16 X 1 1/8 in. (2) Flywheel assembly (2) Camshaft gear 9. 10. 11. 12. 13. 14. 15. Key, Woodruff, No. 404 Nut, plain, hex, 1/4-20 Needle bearing Screw, cap, hex-hd, 1/4-20 Shaft support Gasket Governor yoke bracket 5-8. Camshaft and Governor, Removal, Disassembly, Reassembly and Installation.

TM-10-4930-204-13 Tank and Pump Unit Liquid Dispensing for Truck Mounting (United Manufacturing and Engineering Corp. Model Style 1) Manual
Page Navigation
131

TM 10-4930-204-13 d. Reassembly. (1) Install bearing cone (11, fig. 5-7), bearing cup (10), retainer ring (9) and seal (8) on crankshaft (12). (2) Insert Woodruff keys (7 and 6) in crankshaft and install crankshaft gear (5) and bearing cone (4). (3) Install bearing cup (3), retainer ring (2), and seal (l). e. Installation. NOTE Match timing marks on crankshaft gear to timing marks on camshaft gear. (1) (2) (fig. 5-6). (3) with screws. (4) (5) Install crankshaft and bearing plate. Attach housing to engine base and secure with nuts Install gasket and bearing retaining plate and secure Install flywheel (para 4-24d.). Install pistons and connecting rods (para 5-14). 5-16. CAMSHAFT AND GOVERNOR ASSEMBLY. a. Removal and Disassembly. (1) Remove crankshaft (para 5-15). (2) Remove plug (1, fig. 5-8), support pin (2), spacer (3), and bearing sleeve (4) from camshaft (5). Carefully remove camshaft and gear from engine. (3) Remove cap (1, fig. 5-4) and rod (2). (7). (9). (4) Remove spring pin (6, fig. 5-8) (5) Pull gear (8) from camshaft and (6) Remove nut (10), needle bearing and flywheel assembly remove Woodruff key (11), screw (12), shaft support bracket (13), gasket (14), and governor-yoke (15). 5-15

Privacy Statement
Press Release
Contact