TM 10-4930-204-13(3) Insert stop pin (30) and rotor (29) in housing (35) andinstall bearing (28), support (27), and screw (26).(4) Install ring (25), washer (24), seal (23), washer (22),coupling assembly (21), spring (20), hub assembly (19), bearing (18),key (17), gear (16), nut (15), and connect wire (14).(5) Install contact assembly (13), camwick holder (12),screw (11), ring (10), washer (9), and screw (8).(6) Install capacitor (7) and secure with washer (6) andscrew (5).(7) Install gasket (4), outlet (3), cover (2), and securewith screws (1).e.Installation.Install magneto (para 4-24f.).5-12.VALVES, VALVE SEATS, GUIDES AND SPRINGS.a.RemovalandDisassembly.(1) Remove carburetor, muffler, tappet inspection plate,and cylinder head (para 4-24).(2) Remove locks (1, fig. 5-2), spring seat (2 and 7), andsprings (3 and 8) from crankcase (12).(3) List intake valve (4) and exhaust valve (9) from engineand remove guides (5) and tappets (6).(4) Remove cups (10) and inserts (11).b.Cleanin g,InspectionandRepair.Drycleaning solvent normally has a flash pointof either 100 or 138 degrees F, depending on thetype being used, but may flash at much lower tem-peratures if contaminated with gasoline or jetfuel.Avoid repeated and prolonged skin, contact.Do not use near open flame or excessive heat.(1) Clean valves with wire brush to remove all carbon de-posits.Clean valve seats, ports, and guide in cylinder block; cleantop of cylinder block.Wash springs with drycleaning solvent (item 1,App . F), and dry thoroughly.(2) Inspect valves for burned, pitted, or cracked faces;replace burned, cracked or deeply pitted valve.5-5
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business